INVERTER,S FREQUENCY COMMAND AND OPERATION COMMAND SELECTION

frequency command selection.
0: frequency command is mainly set by operator (d 1 - 0 1) ref off.
1:frequency command is mainly set by exterior terminal 13' 14 ref on flickering .
2:frequency command is mainly set by communication ref flickering.
3: frequency command is mainly set by interface card.

operation command selection.
0: operation command is mainly set by operator seq off.
1: command is mainly set by exterior terminal seq on.
2: command is mainly set by communication seq flickering.
3: command is mainly set by interface card seq flickering.

to execute trial operation by operator.
this section describes the motors trial operation by operator
without load.
the input frequency is set in the operating status.the operation
is example with input frequency'20 h z.





No comments