THE INITIALIZATION OF VC SERIES.

  THE INITIALIZATION OF VC SERIES.

initialization is to reset the value to be factory default. al-03 is used to change the factory default.
note:   after each operation of factory default reset'the carrier frequency need to be set again. otherwise' the inverter could be
damaged. the inverter with different capacity shell have different carrier frequency setting value. please find c 6~0 3 in 4.2.
the content of setting.
 1 setting value 0 .
initialization will not be executed and only go to the initialization
display.
2 setting value 1110.
to memorize the initialization set by user' but not execute.
3 setting value 2220.
2 line system initialization (the initialization of factory default).
3 setting value 3330.
3 line system initialization.
1110 user constant value restoration.
1110 (user constant value restoration) it is operation to change the inverter's constant to the initial value set by user.
110 setting value's operation: when 02-03 is 0'a l-03 is set to be 110 and press enter. then the value will be
changed to the initial value memorized by the user.








the setting of initialized value of 1110:please do according to the below processor after setting the constant
value and memorizing it: press (menu) to jump to the status selection. press(up)key  to go to environment s-
tting mode' and press (data/enter)it .adjust a l-01 (constant access level)to be "4" and go back  to the mode
selection. program mode and set 02-03 (user constant memorizing ) to be 1 and memorize it then go back to
environment setting mode set a l-03 to be 1110 and press (date/enter) to confirm. at this time' the inverter's
constant setting value will be memorized as the initial value of 1110. the constant has not been initialized and
after the operation'02-03 will go back to 0 automatically.

No comments