ELECTRIC INVERTER,S SLIP COMPENSATION PRIMARY DELAY TIME AND SLIP COMPENSATION LIMIT.







SLIP COMPENSATION PRIMARY DELAY TIME.

it is set in units of ms ,

note: this constant dose not normally need to be set , adjust the slip compensation primary delay time if the motor slip compensation responsiveness is low, or if the speeds are unstable . if responsiveness is low lower the setting , if speeds are unstable , raise the setting.setting range is 0~10000.and factory setting is 200.

SLIP COMPENSATION LIMIT.

constant c 3~0 3 sets the slip compensation limit as a percentage of motor rated slip (e 2- 0 2) with the motor rated slip taken as 100%.

note:  it is used to set the slip compensation limit as a percentage of motor rated slip (e 2 - 0 2) with the motor rated slip taken as 100%. if the speed is lower than the target value and dose not change even when the slip compensation gain is adjusted it is possible that the slip compensation limit has been reached raise the limit and then check again make sure however that the value of the sum of the reference frequency and the slip compensation limit dose not exceed the speed capacity of the machinery.



No comments