ELECTRIC THREE PHASE INVERTER,S JOG FREQUENCY REFERENCE AND FREQUENCY REFERENCE UPPER LIMIT.

JOG FREQUENCY REFERENCE.


the frequency reference when the multi function inputs jog frequency reference selection f jog command and r jog command are on.

NOTE:
the frequency reference default value and set value will change when 0 1-0 3 is changed, for example if preset reference 1 is set to 6.00 Hz and 01-03 is changed to 1 (0.01%units ,the setting for preset reference 1 will become 10.00%. when using preset reference 2 through 8 be sure to set multi step speed reference 1, 2 and 3 in the multi function inputs (h 1-0 1 through h 1-0 6 ) as required. when using the jog function set the jog frequency reference in constant d 1-0 9 when jogging from an external terminal set the multi function inputs (h 1-0 1 through h 1-0 6)to jog frequency reference forward jog or reverse jog as required . the multi function input setting is unnecessary when jogging from the operator.

 FREQUENCY REFERENCE UPPER LIMIT.
the frequency reference upper is set as a percentage f the maximum output frequency (e 1- 0 4) in increments of 1%.
setting range is 0.00~110.0 .
factory setting is 100
change during operation is x.
v/f is b .
f/f with pg is b.
open loop vector is b ,
flux vector is b .

No comments