SPEED LIMIT AND TORQUE CONTROL SELECTION .



SPEED LIMIT.
to get the frequency after plus minus calculation of analog frequency command ,it is in unit of % with the maximum output frequency taken as 100% .

NOTE:
the trim control level is valid when the trim control increase command (setting, 1 c) or trim control decrease command (setting , 1 d)is set for a multi function input (h 1-0 1 to h 1-0 6) , if the trim control increase command is on when a frequency reference is input the trim control level will be added to the analog frequency reference and then output as the output frequency . if the trim control decrease command is on the frequency reference will be decrease by the trim control level . it is set in unit of% with maximum output frequency taken as 100% . if the frequency reference minus the trim control level is less than zero ,the output frequency will be zero . refer to the description of multi function inputs (h 1)for detail on the trim control increase and trim control decrease commands.

TORQUE CONTROL SELECTION.
0:speed control (c 5-0 1~0 7 control) 1:torque control.

NOTE:
to set d 5-0 1 to be 0 when the switching function of speed control and torque control is used to set d 5-0 1 to be 1 in the event of torque control. ( setting range 1~1000 )

No comments