INVERTER,S OUTPUT MODE SELECTION AND FREQUENCY MULTIPLE SELECTION .



OUTPUT MODE SELECTION .

Set the output  mode  in the following constants when using a d0-08 digital output card 0: - channel individual outputs  code output ( binary system code) .
note: the item output by d0-08 according to f6-01 setting , please set the code output as follows.

(setting value 0:output respectively =terminal no =================output content
from 8 channels)
===========================td5-td11==================over current(sc,oc,gf

============================ td6-td11==================over voltage (ov)

============================ td7-td11=================inverter overload (ol2)

============================td8-td11===================fuse blown -out (puf)

============================td9-td11=================== over speed (os)

============================td10-td11========inverter overheating (oh1)or motor                                                                                                             overload(ol1).

============================td1-td2 ====================zero-speed detection

============================td3-td4====================speed conforms

1:code output binary system code=======td5-td11=========================bit 0

==============================td6-td11=========================bit 1


=============================td7-td11==========================bit 2

=============================td8-td11==========================bit 3

=============================td9-td11================zero speed detection

=============================td10-td11===============speed conforms

=============================td1-td2=================in operation

=============================td3-td4=================minus fault

FREQUENCY MULTIPLE SELECTION .

To set the number of output pulses , it is effective when pulse monitor card is used, 0: 1f  1:6f  2:10f
3:12f    4:36f
note:when pulse monitor card is used please set the number of output pulse according to the above parameter , f  denotes output frequency , for example when o(1f) was set output frequency is 6o Hz ,
and then there will be 60 pulses to be output with in 1 second (frequency dividing ration 50%) .





No comments