MOTOR 2 LINE TO LINE RESISTANCE AND MOTOR 2 LEAK INDUCTANCE .

MOTOR 2 LINE TO LINE RESISTANCE .


To set the motor,s line to line resistance in unit of ohm .
note: the factory setting depends on the capacity of the inverter . please set the motor,s line to line resistance u v v - w w u  normally you need to inquiry the factory for the line to line resistance . the value can be calculated according to the following insulation  E : line to line resistance at 75 degrees(ohm)x 0. 92(ohm) insulation B :line to line resistance at 75 degrees (ohm) x 0.92 (ohm) insulation F : line to line resistance at 115 degrees (ohm) x 0.92 (ohm)

MOTOR 2 LEAK INDUCTANCE .





Set the voltage drop due to motor leakage inductance as a percentage of the motor rated voltage .
note: the factory setting depends on the capacity of the inverter . the value setting range 0.0 ~40.0 for the inverter with 0.4 kw and 200 volt , set the voltage drop (caused by the motor,s rated voltage this constant dose not normally required setting because the inverter automatically compensates during operation normally this value is not shown on the motor nameplate  , so it might be necessary to contact the motor manufacturer .

No comments