PG CONSTANT AND OPERATION SELECTION AT PG OPEN CIRCUIT .





PG CONSTANT .

To set the pulse number of generator or encoder when pg is used
note:to set the pulse number of generator or encoder when pg is used. the unit s p/r  . set the number of phase a or phase b pulse s in one motor revolution.


OPERATION SELECTION AT PG OPEN CIRCUIT .

This constant sets the stopping method that is used when the signal from the pg is lost. 0: deceleration to stop using deceleration time 1( c 1-0 2). 1: cost to stop  . 2: emergency stop using the emergency stop time (c 1- 0 9). 3:continue operation ( display :P G O: and continue operation with v/f control.
note: please set the detection time when pg signal wire is disconnected and the stop method sifter the signal wire loss is detected .


No comments