440 VOLT (ELECTRONIC) INVERTER,S CONSTANT DESCRIPTION .



BASE TERMINAL 13 .

The input is the frequency at 0,v , it is set in unit of % with max . output frequency taken as 100% please referee to h3- 11 .

SIGNAL LEVEL SELECTION TERMINAL 16 .

Please see the signal level of multi functional analog input 0:0~ + 10 volt [11 bit +polarity positive / negative ) input ] 1: 0 ~+_ 10 volt (negative voltage , it  becomes the opposite direction operation ) .






MULTI FUNCTION ANALOG INPUT TERMINAL 16 .

It is used to set the function of multi functional analog input terminal 16 . set the signal level  deviation , gain of the analog input in the following contacts .

signal level selection of multi function analog input terminal 16 ,(h3-4 , 0~+ 10 volt or 0~+_ 10 volt)
input gain of multi function analog input terminal 16 , ( h3_06) .
input 0 t set of multi function analog input terminal 16 , ( h3_07 ) .
signal level selection of frequency command ( current ) terminal 14 , h3 _ 08 ( 0~+ 10 volt or 0~ +_10 volt or 4~ 20 m a ).
input gain of frequency command (current ) terminal 14 , ( h3-10) .
input offset of frequency command  ( current ) terminal 14 , ( h3 - 11 ) .
when input the voltage to the frequency command ( current ) terminal 14 , please make sure to cut off the overlie on control paced . if not to cut off the overlie the input resistor will be burned . when primary delay filter was connected to analog input please set the time constant . it is applicable to the entire three analog input terminals . the setting of 2 and D cannot be set at the same time otherwise ope 07 will not be detected .

No comments