ELECTRIC THREE PHASE INVERTER,S CONSTANT FUNCTION INTRODUCTION .

h2-01,multi function input (terminal 9-10 ) is multi function contact output terminal 9-10,s function selection (contact ).
h2-02,multi function input (terminal 25-27) is the function selection of multi function output 1 terminal 25 (open  circuit collector) .

h2-03 multi function input (terminal 26-27) is the function selection of multi function output 2 terminal 26 function output .

MULTI FUNCTION,S OUTPUT .

setting value 0 is operation ( on operation is on or when voltage is output) .
setting value 1 is zero speed .
setting value 2 is frequence(speed)conformity 1(on:output frequency + _ l4-01,detection width l4-02)
setting value 3 is any frequency (speed)conformity 1(on:output frequency +_ l4-01,detection width l4-02)
setting value 4 is frequency (fout) detection 1> (on+_l 4 - 01 detection width l4 - 02  )
setting value 5 is frequency ( fout ) detection 2 . (on : output frequency >_ + l4 _ 01 or out put frequency >_ l4 detection width l4 -02  )
setting value 6 is inverter operation preparation is ready note :preparation is ready : no abnormal statu after initialization )
setting value 7 is in  course of low - voltage detection of main circuit
setting value 8 is base  electrode is locked ( on : base electrode is locked )
setting value 9is frequency command selection status ( on: operator )
setting value a is  operation command selection status (on : operator  )
setting value b is over torque detection 1 no ( when contact a is on torque will be detected
setting value c is frequency reference missing ( when l4 - 05  is selected to be 1 , the frequency reference missing operation i enable )
setting value d is braking resistor multi function (on , resistor heating or braking thirstier fault ).
setting value e is abnormal ( on , fault occur except cpf 00,cf01) .
setting value f is disabled (please do not set it ) .
setting value 10 is minus fault (on , display as warning ).
setting value 11 is in the course of fault reset .
setting value 12 is timing function output .
setting value 13 is frequency ( speed ) conformity 2 ( detection width l4 - 04 )
setting value 14 is any frequency (speed) conformity 2 (on , output frequency =l4-03 , detection width l4-04 ) .
setting value 15 is frequency ( fout ) detection 3> (on , output frequency >_- l4 - 03 , detection width l4-04) .
setting value 16 is frequency ( fout ) detection 4> (on , output frequency >_- l4-03 , detection width l4-04 .
setting value 17 is over torque detection 1 nc ( over torque is detected when contact b, off) .
setting value 18  is over torque detection 2 no (over   torque is detected when contact a is on ) .
setting value  19 is over torque detection 2 nc (b contact , off over torque detection ) .
setting value 1a is reverse operation (on , in reverse operation ) .
setting value 1b is base locking 2 (off , base is locked ) .
setting value 1c is motor selection ( on , the second motor is in selection ) .
setting value 1d is regeneration action (on , in action of regeneration ) .
setting value 1e fault reset retry ( on , in fault reset  retry ) .
setting value 1f is motor over load  0l1  warning prediction (on , 90% of detected value or above ) .
setting value 20 is inverter overheating 0h warning prediction ( on  , temperature is above l8-02).



No comments